3/2/2024 0 Comments Computer notes hindiIt works more easily for higher-priority tasks. Continuous request for bus control is generated by this Data Transfer Mode. Cycle Stealing Mode: In Cycle Stealing Mode, buses are handed over to the CPU by the DMA after the transfer of each byte.Burst Mode: In Burst Mode, buses are handed over to the CPU by the DMA if the whole data is completely transferred, not before that.There are 3 modes of data transfer in DMA that are described below. Control to define the mode of transfer such as read or write.It also sends word count which is the number of words in the memory block to be read or written.The starting address of the memory block where the data is available (to read) or where data are to be stored (to write).When BG (bus grant) input is 1, the CPU has relinquished the buses and DMA can communicate directly with the memory.Įxplanation: The CPU initializes the DMA by sending the given information through the data bus. When BG (bus grant) input is 0, the CPU can communicate with DMA registers. Through the use of the address bus and allowing the DMA and RS register to select inputs, the register within the DMA is chosen by the CPU. The unit communicates with the CPU through the data bus and control lines. The figure below shows the block diagram of the DMA controller. Therefore, the CPU can both read and write into the DMA registers under program control via the data bus. Note: All registers in the DMA appear to the CPU as I/O interface registers. Control register – It specifies the transfer mode.Word count register – It contains the number of words to be transferred.Address register – It contains the address to specify the desired location in memory.The DMA controller registers have three registers as follows. Interleaved DMA: Interleaved DMA are those DMA that read from one memory address and write from another memory address. Software Engineering Interview Questions.Top 10 System Design Interview Questions and Answers.Top 20 Puzzles Commonly Asked During SDE Interviews.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |